 |
| 1. Here are the parts we needed. |
 |
2. We required a cutter for the next step. |
 |
| 3. Make two deep cuts using the cutter. |
 |
| 4. Put the shorter end of the pins underneath the copper strip board and between a cut. Next, we soldered the shorter end of the pins to the board. |
 |
| 5. This is how it looks at the top of the board. The pin with the red dot will be connected to RD0 and pin with black dot will be connected to GND, if the rainbow wire connectors were done properly. |
 |
| 6. Use wires to link between the components to the newer made connector on the board. |
 |
| 7. Here we had completed the linkage between the boards through rainbow wire connectors. |